Outward Swing Door Security – Out-swinging doors may appear to be highly secure, but they have a number of major flaws that make them easy points of entry for burglars to break into. Outward doors can’t be kicked open because of their door frame design. However, the hinges on the exterior doors can pose a security risk. With a screwdriver, you can pop the pinout and then remove the door. As with any other door, a shaky lock can pose a security risk.
A broomstick or a security bar can be used to secure an outward-opening door, or a rope, power cord, or a belt can be tied to the door handle and a large piece of furniture. Those who try to open the door will be forced to either pull on the furniture or the security bar. Both are extremely unlikely to be broken.
However, securing an outward-opening door when leaving the building is a major issue. As a result, long-term structural solutions are also required. As a result, the following are the most effective outswing door security measures and devices:
Best Method To Outward Swing Door Security
1. Security Bars for Outward Swing Door Security
An outswing door can only be secured from the inside by using this method. Place a security bar under the door handle or knob and perpendicular to the door. The door won’t open if someone tries to open it by pulling outward because the bar is in the way.
A broomstick or metal bar that’s longer than the door’s width can be used for this purpose. On the other hand, you could tape them to the wall or door frame on both sides to keep them in place. However, there is a risk that the tape will come loose and fall off over time if you use a completely DIY setup. It’d be a pain if you had to tape them up all the time too.
There are only two options here: a) construct something to hold the DIY bar firmly in place, or b) buy an actual security bar that comes with the proper screws or brackets to do the job for you.
For the hooks and main bar to fit into, you’ll need to drill a permanent square tube into the door. In the event that a padlock is desired, holes can be found on the hooks’ tips.
But don’t be alarmed; the setup is straightforward, and an instruction manual is included. What one user had to say about it is as follows:
The search for a way to secure an outward swinging door occupied months of my time. Anything I tried didn’t work except for this item. Installation is a breeze. Basically, all you need to do is drill two 5/16-inch holes in the door and then screw it all together. There are two trucks needed to remove your door after it has been installed. The outside isn’t where they’re coming from.
I’m confident in recommending this set to my readers because almost every verified customer has given it a 5-star rating. On Amazon, you can see the current price and learn more about this bar’s features.
2. The doorknob can be tied to a large piece of furniture.
This is a simple, cost-free method that works well. A rope, a power cord, or a belt are all you need. One of them can be used to secure the doorknob to a piece of heavy and wide-opening furniture. Closets, heavy tables, work desks, and the like are examples of useful furniture.
But if the intruder is able to pull the furniture to within a few feet of the door, the door can still be opened. This means that the furniture must either be placed very near the door or be extremely heavy in order to be moved. The task could be made even more difficult if you place another piece of furniture or an obstacle in the way.
It’s also possible that the furniture you’re using could be damaged if it’s moved across the floor and slammed on the floor. As the room becomes disorganized, it’s possible that the walls or other furnishings will sustain damage.
Consider these issues if you plan on using this method. To test your ability, open the door and see if it works. Only then can you tell for sure that the furniture is in proper position and that the rope or other material you’re tying it to the doorknob is sufficient.
3. Install a Latch Guard for Outward Swing Door Security
Plate covers that extend from the door’s opening side are known as latch guards, and they are designed to deter trespassers. Their size can vary, but they’re usually quite small and won’t ruin the look of your door if you pick the right color. There are latch guards for inswinging doors, but I’m only interested in outswing doors at this point in the article.
A latch guard must be installed, but how? You can see how it’s done even if you don’t have an outswinging door. You can also refer to the product’s instruction manual. The video
Due to its durability (it’s made of heavy-duty stainless steel) and versatility (it can be used on most residential, commercial, and even industrial outswing doors), this Prime Line latch guard from Amazon is the most popular one for outswing doors.
There are all of the fasteners needed for installation included in the package, so you can get the job done in a matter of minutes. Both 3″ x 7″ and 3″ x 11″ sizes are available with a 1/4″ offset.
If you have a door with a single handle instead of a deadbolt, this latch guard won’t work for you. This combination is not supported by Prime-Line.
4. A door lock hinge protector for Outward Swing Door Security
A steel outswing door hinge protector from Amazon
After removing the hinge pins, this hinge protector prevents thieves from lifting out a steel door. Most steel doors can be used, and it doesn’t require any additional hardware or adjustments.
“To install it, make sure the holes in the door edge and the frame of the two hinge sections are perfectly aligned. A more precise method is to use a blind hole spotter punch. The holes in the hinge halves can also be aligned by measuring and scribing center lines.”
When the door is closed, the stainless steel pin mounted in the hinge half of the door slides into the corresponding hole drilled in the hinge half mounted in the frame, securing the hinge side of the door to the frame.”
Even if the intruder completely removes the exposed portion of the hinges, he will still be unable to pry the door open.
5. Install Non-Removable Pins in Security Hinges Outward Swing Door Security
Installation of non-removable door hinges is another option for securing your home. It’s possible to use these stainless steel ball bearing door hinges on doors ranging in thickness from 1 5/8″ to 1 3/4″.
The three hinges and matching wood screws cost about $40. They’re a good deal. I haven’t used these myself, but I do have a similar set on a door in my office. Installing these security hinges is a no-brainer, as they have received excellent customer feedback and are a straightforward item.
Providing the door is not too thick or heavy, they should work perfectly and prevent the removal of the door from the frame or track.
Outward Swing Door Security
It’s easy to assume that doors that open outwards are secure, but this isn’t always the case. This article will focus on the security of outward swinging doors.
The door frame on the outer door means it cannot be kicked in hard. External door hinges, on the other hand, pose a safety risk. Using a screwdriver, the pin can be quickly ejected, and the door can also be removed. Weak door locks, like weak doors in general, pose a threat to your home’s security. As a result, the security of an outward-swinging door is more critical than that of any other type.
For doors that open outward, it seems nearly impossible to find a suitable solution for safety devices designed for doors that open inward. However, there are ways to fix these issues that aren’t prohibitively expensive.
To keep the door from slamming open in the opposite direction, you can secure it with a safety rod or broomstick, a rope, power cord, or a strap. A safety bar or other piece of furniture can be used as a barrier for anyone trying to open the door. All of them are impenetrable.
It’s important to remember to leave the door open when leaving if you can only use an outward-opening door. As a result, we must look into long-term structural options as well. Because most doors in the United States swing inward, I’ve been unable to find much information on outward swinging door security. Here are a few options for outward-swinging door locks.
Outward Swing Door Security Conclusion
A question about outward swinging door security should no longer be a concern if you use the above-mentioned security measures.
For outswing door security, there aren’t many options. Because of the way these doors open, they are more secure by design. However, a clever thief who knows how to manipulate the lock or make the hinges obsolete can still get their hands on them.
Both of the aforementioned issues are fully addressed by the four approaches and devices I’ve described above. So I hope you take advantage of them and put any remaining doubts about the security of your outswing door to rest.
Other entry points, such as ground-floor windows and sliding glass doors, can also be secured in the same way as your front door. Using a door alarm that sounds if it detects any movement at the door or a security video doorbell are all viable options.
Floor-to-ceiling windows and sliding glass doors, on the other hand, can be used to secure doors and other points of entry. It’s possible to use a home security camera, video doorbell, or a warning siren, all of which close when you open the door and detect any vibration.
If you have additional questions, please feel free to post them in the comments below. I’d be delighted to help you find the answer to your question and to share my findings with you.